Resize a piece to fit you, with wearing ease

Every blank starts at an average adult's size. Resize to fit sizes the piece's fitted ring — the one that has to go round you — to your measurement plus some room.

Before you start

1. Open Fit & export

   On the Model tab, find the Fit & export card.

2. Pick your body

   Under Fit to measurements, choose your profile. Every Workshop tool shares the choice.

3. Set the ease

   Wearing ease (cm) — room for padding, a wig cap and to move. It starts at 1.0 cm; up to 6 cm.

4. Resize

   Press Resize to fit. It scales the piece's width and depth — never its height.

See it on you

Tick Show the wearer to see a body built from your profile under the piece. Where a number is missing it uses an average adult's, and says so — Measure them › fills them in.

When a measurement is missing

1. Save first

   Save the design (see part 4), so there's something to come back to.

2. Measure it

   Where the button was, it reads … has no head circumference yet. Press Measure it › and take it in the Measuring Room.

3. Come back

   Press Back to Piece Forge → at the top of the room. Your design reopens; press Resize to fit.

If something's off

“A pauldron has no body measurement to fit — scale it by eye.”

Pauldrons and props aren't fitted to a measurement. Shape them by eye with the wearer showing, or set ring sizes by hand in the Rings card.

Resize to fit is greyed out

Choose a profile under Fit to measurements first.

The piece is the right width but too tall

Resizing never changes height. Drag the top ring's handles down, or remove a ring.